Back to all

Keeping Your Engine Cool in Homer Glen, Illinois

April 5, 2016



The cooling system keeps Illinois vehicle's engines from overheating while they are driving around Homer Glen. Its job is to move heat away from the engine. Let's talk about the various components of the system and how they make this happen.

The radiator is the part most Homer Glen drivers associate with the cooling system. Coolant flows through the radiator which has fine cooling fins that draw the heat out of the coolant and dissipate it into the air. To make sure there's enough airflow over the radiator, a fan pulls air over the cooling fins even when the vehicle is idling.

In some vehicles, the fan is powered by the serpentine belt. On others, an electric motor runs the fan. Electric fans turn on and off as needed. You may have heard the fan kick on shortly after you turn your vehicle off. The sensor has determined that the engine needs a little help cooling down to a safe temperature.

A hose connects the radiator to the water pump. The water pump pushes the water into the vehicle engine block. Now the engine block and cylinder heads have passages for the coolant to pass through without getting into the oil or the combustion chamber. In the automotive community, these passages are referred to as the "water jacket."

While the coolant is passing through the water jacket, it absorbs heat from the vehicle engine on its way to the radiator for cooling. Between the engine and the radiator is a gatekeeper called the thermostat. The thermostat's job is to regulate the temperature of the engine just like your home thermostat regulates the temperature in your house. It gets your engine up to the correct operating temperature and then keeps it from overheating.

When you first start the engine, it's very cold and needs to warm up. So the thermostat blocks the flow of coolant to the radiator. As the engine warms up, the thermostat starts to let coolant flow through the system.

The final component the team at Tuffy Tire & Auto Service Homer Glen wants to point out is the overflow reservoir. This bottle is designed to hold some of the coolant. It'll have a mark that indicates whether or not you have enough coolant. This is where you should add coolant if you just need to top it off.

Caution: never open the reservoir or the radiator cap when the car's hot. The cooling system is pressurized, and opening those caps while it's hot can cause hot coolant and steam to escape resulting in serious burns.

Cooling system failure is the most common mechanical failure in vehicles around Homer Glen, Illinois. At Tuffy Tire & Auto Service Homer Glen, we can do a periodic inspection of the components for  leaks, loose connections and weakening hoses.

Your vehicle manufacturer has also specified a cooling system service interval. With a cooling system service at Tuffy Tire & Auto Service Homer Glen in Homer Glen, the old coolant is replaced with correct clean fluid that contains the additives required to prevent corrosion. The additives are depleted over time and you need fresh fluid for adequate protection. Your radiator pressure cap should be replaced at this service as well.

Tuffy Tire & Auto Service Homer Glen
15743 S Bell Rd
Homer Glen, Illinois 60491
708-301-8885

More articles from Tuffy Homer Glen

The Light Nobody Wants to See (Check Engine Light)

April 28, 2024

You've probably had your Check Engine Light go on. Then it goes off and you figure, hey, whatever the problem was, it's gone now and I don't have to worry about it. Well, the problem may have gone away and it may not have. Your vehicle likely has one of these warning lights on the instrument pa... More

Losing Your Cool (Why is My Air Conditioning System Not Working?)

April 21, 2024

When you turn on the air conditioning in your vehicle, you expect cool air to come out of the vents. You depend on it, especially in hot weather, but it can also be important in humid weather when you need it to help defrost your windows and windshield. The air conditioning system has a lot of p... More

Snake in the Engine (Serpentine Belt)

April 14, 2024

There's a belt that snakes through your engine. It's even named for a snake, the serpentine belt. It'll bite you when it breaks, possibly leaving you stranded. So, it's good to know a little about this snake-like belt. In early engines, there were lots of belts. They were used to convert the r... More